4318S TITAN ALUMINUM 18" FULL FRAME HOSE REEL STAINLESS MANIFOLD
many in stock
4318s full frame titan products manual hose reel with upgraded 1/2"" fpt super swivel (8620a) w/ zerk fitting and 1/2"" id stainless steel manifold suitable for softwash chemicals. please leave a note at checkout. if no note is left, we will send either swivel.
the 4318s is by far the most popular hose reel we offer to our pressure washers and softwashers. this reel can be stacked with another reel of the same width on top or below using a titan products stack kit (tt7054). we offer the reel with the upgraded 1/2"" fpt super swivel (8620a) with a zerk fitting instead of the standard stainless swivel cnc'ed in-house by titan. we discovered over the years that the super swivel lasts longer when exposed to hot, high pressure water and softwash chemicals because it can be maintained with a grease gun. the 1/2"" stainless steel manifold is connected to the the swivel and runs through the center of the reel and makes up the wetted components. as with most belongings in life, the better we take care of them, the longer they last. adding a 3 way ball valve to your softwash set-up will allow you to easily rinse the reel and pump after every use.
don't forget to add the street 45 in brass for chemical or low pressure use (2354) or in steel (3361) to avoid the kink that occurs on the outlet of the hose reel as the hose connects and lays again the reel.
if you are trying to choose between the full frame titan hose reel and the u-channel series, consider the following: the lock is standard on this reel and all reels in the 4300 and full frame series. the u-channel reels (4800 series) do not offer the hose reel lock in the standard build but a bungee cord can be wrapped around the hose to prevent unravelling down the road. the full frame can handle a bit more abuse and pulling hose from the sides without 'tweaking' the reel. the full frame reels can be stacked easily and the u-channel cannot. the u-channel can be more easily mounted on the side railing of an open trailer without requiring too much fabrication while the full frame reels require a bigger support footprint.
capacity: holds 325' 1/2"" id flex tech rt, kuri tec or yellow ag hose with crimped on stainless steel ends or 225' 5/8"" id, flex tech rt, kuri tec or yellow ag hose with crimped on ss hose ends we can cut a jump hose to your exact length and crimp on the hose ends for both high pressure and low pressure hose. a custom length of hose can be assembled in just about any hose we can get our hands on. we can offer a wide assortment of hose ends. we always recommend a two wire (r2) high pressure hose from your unloader on your pressure washer to the hose reel.
please see our jump hose section or we can make a custom length.
you need two reducing bushings (2578) and a street 45 (3361) plus a two wire jump for this reel. if your pressure washer has a plug on the outlet, you need a 3/8"" female coupler (2401 or 4630 ss), a 3/8"" female plug (3878 or 4959 ss) and a 3/8"" male coupler (3004 or 4960ss) to install the jump hose to this reel.
this reel has the estimated capacity to hold the following hose inner diameter hose lengths: 625' 1/4", 450' of 3/8", 325' of 1/2" and 225' of 5/8".